Skip to content
Request a Quote + Certification

Supporting service

CMM Programming

Request a quote for program development or revision.

Request a quotation

Pricing is set out in writing and sent by email.

A program that measures the print, not just runs

Program development starts from the drawing or model, with GD&T interpreted into a datum structure and alignment strategy before a single point is taken. Fixture and feature strategy follow the part, not the machine's default routine.

Platforms in use across the region's Tier 1 suppliers include PC-DMIS, Calypso, MODUS, CAMIO, PolyWorks and Quindos.

What's covered

Programming support spans new part introduction through legacy program revision and reporting output.

  • 01

    Datum and alignment

    Datum structure is built from the print's reference frame, not an arbitrary machine coordinate system.

  • 02

    Probe and stylus selection

    Stylus configuration is chosen and qualified for access, deflection and feature size before programming begins.

  • 03

    Scanning vs. discrete point

    Scanning mode is specified where form data is required; discrete points where it is not.

  • 04

    PPAP and first-article output

    Report format is built to match the supplier's PPAP or first-article submission requirement.

Development sequence

  • 01

    Review print

    GD&T callouts, datum structure and critical features are identified from the drawing or model.

  • 02

    Plan strategy

    Fixturing, probe configuration and measurement sequence are laid out before programming.

  • 03

    Build and test

    The program is run against a known-good or first-off part and checked against expected results.

  • 04

    Deliver and document

    Finished program, stylus file and reporting template are handed over with the part.

Why Louisville CMM Calibration and Repair

  • 01

    Print-driven datum structure

    Datum structure is built from the drawing's reference frame, not a default machine alignment.

  • 02

    Platform-matched

    Programs are built in the software the shop already runs, not converted after the fact.

  • 03

    Stamping and forging experience

    Programs account for the datum schemes typical of structural stampings and forged driveline parts.

Coverage across Kentucky and the Greater Midwest

On-site scheduling is confirmed by metro and travel distance at the time of quote; ship-in service is available outside the stated radius.

Discuss CMM Programming Requirements

Send the print, model and platform for a programming quote.

Pricing is set out in writing and sent by email.
Request a Quote + CertificationEmail us